All toolsFree calculator
Stencil area-ratio calculator
Enter the aperture size and foil thickness to see whether solder paste will release cleanly from the stencil.
Stencil area ratio
AR = L·W ÷ (2(L+W)·T)
Area ratio
Marginal0.656
ratio · min 0.66
Below the 0.66 guideline. Release may be patchy: use a foil of 0.126 mm or thinner, a larger aperture, or a nano-coated or electroformed stencil.
- Aspect ratio (width ÷ foil)
- 1.97 · min 1.5
- Opening area
- 0.125 mm²
- Wall area
- 0.1905 mm²
- Thickest foil for 0.66
- 0.126 mm · 4.97 mil
The rule
When the squeegee lifts, paste is pulled two ways: onto the pad by the opening area and back into the stencil by the aperture walls. The area ratio compares the two. Above 0.66 the pad usually wins and the paste releases; below it, paste starts to stay behind.
The aspect ratio (narrowest opening ÷ foil thickness) should also be at least 1.5. Long, thin slots can pass the area ratio and still fail this one.
Formula
Rectangle: AR = (L × W) ÷ (2 × (L + W) × T) Circle: AR = D ÷ (4 × T) Aspect: W ÷ T (or D ÷ T) Pass when AR ≥ 0.66 and aspect ≥ 1.5
Typical values and sources
- IPC-7525, Stencil Design Guidelines: area ratio above 0.66 and aspect ratio above 1.5 for laser-cut stainless foils.
- Area ratios of about 0.5 to 0.66 are often workable with nano-coated or electroformed stencils (typical value; shown as Marginal).
- Common foil thicknesses are 0.1, 0.12, 0.127 (5 mil) and 0.15 mm.
Limits differ between fabs. Treat these as starting points and check your fab's capability page.
More calculators
- Via aspect-ratio calculatorBoard thickness and drill size to aspect ratio, against common fab limits.
- Finished-hole calculatorDrill size, plating and tolerance to finished hole size.
- Copper-weight converteroz/ft², µm and mil, with typical finished thickness.
- Panel-utilization calculatorBoard size, spacing and rails to boards per panel and material use.